G&G - GC-16 Predator - Battleship Grey (Mosfet & ETU)

G&G GC-16 Predator -Battleship Grey with inbuilt Mosfet & ETU (GC Intermediate)

Metal Body (GC Intermediate)(EGC-016-PTR-BNB-NCM)

The GC16 Predator brings the "War fighter/Wirecutter" style to the G&G GC16 range, the heavy weight front end with specially recessed "C-Cut" on the front of the quad rail, This hides the flash suppresor *IN* the rail system, which gives the rifle a "Low Visibility" profile.

The Predator comes with a "best of both worlds" quad rail, featuring KeyMod on the sides and monolithic style picatinny 20mm rail on the top and bottom. The external packaging is completed with G&G Flip up front and back iron sights, Six position adjustable stock with storage compartment, a full metal receiver and 300 round hi capacity magazine.

E.T.U. & MOSFET

The GC16 Predator comes with the new G&G "Electronic Trigger Unit" This can be programmed to switch between fully automatic and 3 round burst, simply by holding down he trigger for 10 seconds. The E.T.U. has also been designed to give the player a faster trigger response and to prevent trigger burn out.

It also comes with a pre-programmed MOSFET chip to stop over discharge issues.

Features

- Overall Length 810 mm

- Weight 2599 Grams

- Gear box bearing 8mm Ball Bearings

- Motor 25000rpm Hi-torque Long axis

- Inner Barrel Length 260mm

- Magazine 300 Rounds

- Material Stainless/Aluminum/Steel//Nylon/Fiber

- Inbuilt Mosfet

- GC Intermediate Range

Please note: This G&G AEG is rated for use with 9.6Volt Nickel Metal Hydride batteries (Nimh) only. If you intend to use Lithium Polymer (LiPo) batteries. Please seek advice from the support team. Use of LiPo batteries in this AEG will not be warranted.

"We would like to take the opportunity to address a commonETUissue customers are experiencing. The tact switch in theETUis designed to be used for quickandlight use. Any excessive heavy trigger pull will cause the tact switch to breakandmalfunction. The travel distance of the tact switch is only 0.2mm. Thus, the trigger will respond without being pulled all the way down. Continuous pulling on the trigger after BB has been fired is unnecessaryandwill damage the unit."

Please note that the use of 11.1v lipo batteries will void your warranty ? The internal micro switches are delicate. The trigger switch has a stop designed to protect it and excessive trigger pressure against this stop (pulling the trigger further back than it will go) will damage the unit and this will also not be covered by warranty